Recent content by Dudge

Help Support SkidSteer Forum:

  1. D

    No EIC display but engine runs fine..need help diagnosing EIC issue.

    Just an update…still need help…lights are working….engine fires up and runs with no issues..boom, bucket all working as they should. When I turn the ignition on the warning beep sounds, normally this stops when the heater cycle has run, but it is staying on all the time. If I push and hold the...
  2. D

    No EIC display but engine runs fine..need help diagnosing EIC issue.

    My ls140 has been parked for a while..I went out to charge it today to get it up and running. I noticed that the ignition key slot was about halfway between off and position one but thought nothing of it (it's always been slack) However once the battery was charged I get a constant high pitched...
  3. D

    drooping issues and then tonight big bang! Help...

    Hi. I have a NH ls140..its done around 1900 hours and in general is in really good condition and well maintained. I really like it but it is a touch underpowered when lifting...I have noticed over the last couple of months that occasionally the forks or bucket droop when stationery..but I can...
  4. D

    Ls140 lifting surprise...and pallet forks.

    Thanks or the reply. I think you have nailed the hissing...it feels very much like the hydraulics have reached their capacity and a relief valve is doing its job. I dont know why but i thought the 140 would tip forward if the weight was too much before the relief valve let go. It is a large...
  5. D

    Ls140 lifting surprise...and pallet forks.

    Hi all. Couple of quick questions... I had some thermalite blocks delivered the other day..I think the pallet weighed around 560kg...I was surprised (and annoyed) that my skid couldnt lift them off the ground..it just made a hissing noise and wouldnt budge them...now I have noticed my bucket...
  6. D

    LS140

    Thanks..I didn't see the manual thread but thought there might be one here.
  7. D

    LS140

    Hi New here and have looked around and searched but can anyone point me in the direction of a user/operator/owner manual for a ls140. I have just bought one and while most things are fairly obvious I would like to know I am fully up to speed. I can find loads of downloads for maintenance...
Top