Recent content by doger5

I have had his problem with my 743 . The ground wire from the battery to the machine had corroded on the inside, everything seemed to look good . Check voltage from connecting the positive side of the battery and grounding the tester negative to the frame.

I used a Dremel and a chisel slow but worked.

Non-Detergent SAE 30W , I use this oil in my 743

I bet your Manual SAYS 10W30 motor oil

I know when you change the seal on the chain case there is a quad seal behind this seal that should be changed as well .

A chain is only a strong as its weakest link . I agree , no slip links

Vancouver Regional District Ticket Information Utilization Amending Bylaw No 1158, 2012 Reference: Greater Vancouver Regional District Non-Road Diesel Engine Emission Regulation Bylaw No, 1161, 2012 Column 1 Column 2 Column 3 Offence Section Fine 1. Discharge of air contaminant 6 $1000 2...

Use the link above and calculate your engine in Metro Vancouver and surrounded area , This is a money grab by our local government while the harbour is full of old ships burning bunker oil in Vancouver that is regulated by the federal Government

https://apps.metrovancouver.org/NRDE/tools/feeestimator.aspx

Its all 5 % biodiesel in Canada

I think California has similar rules

I think its starts at 1000 dollars and up to 200,000

You can see my problem , I need to get this motor to tier two

This engine is classified as a Tier 0 and is required to be registered to operate in Metro Vancouver. Tier 0 engines will be prohibited from operating in Metro Vancouver unless 90 days of registration have been purchased and started on or before December 31, 2014

http://www.metrovancouver.org/services/Permits-regulations-enforcement/non-road-diesel/faqs/Pages/default.aspx In metro Vancouver they can , you cannot operate a tier 0 1998 or older diesel engine