Recent content by dhardin53

I have straightened a bent bucket by placing a 2 or 3" block of steel on the outer ends of the bucket resting on the concrete. Then very carefully backed a dump truck on to the bucket edge. Forcing it down. Its easy to over correct it this way but going slow and just the right heights in spacers...

I do have a rob from cab to governor arm. from this governor arm there is a spring that has a rod on the back end of it. this rod is attached to a fulcrum type assembly on the back of the motor back under the intakes by the fuel pump. This is how i got the motor. On this fulcrum type assembly is...

Got a question for any Wisconsin VG4D users. I'm installing a new Wisconsin rebuilt motor in my 1530B Case skid steer. I did not take it out so i don't know just where the wire throttle coming from the hand control is attached to the linkage to the carb/ Governor system. A pic would be a pic of...

Just got back from picking up my 1530B. What a heavy duty machine, just about all I wanted to hale some 200 miles home, Its a Beast. I got a refurbished from factory 37hp Wisconsin never been run yet. I think it had 30hp in it before. Now i hope to find or make a ROP cage It has the safety...

Just bought a 1530B and have not yet picked it up. I have a lot of questions. 1. How heavy is the unit? 2. Whats the pump GPM and out put PSI? 3. What other Case uni-loader is this compared to? Not finding much in the Case web site on this old of loader. 4. Whats the lift capacity and tip over...