Recent content by DFS2005

I tried it briefly after I got the motor on, but the ground was still pretty wet. My plan is to do some tilling this weekend.

I have yet to use it. The new motor is supposed to be here today. Then I will have to wait for things to dry out its done nothing but rain or snow for the last few weeks.

Yea that shaft was made of crap metal and not even remotely properly hardened. Hard to see in the picture but it is twisted some. I am in agreement about avoiding their equipment. Says a lot about a company who wont talk to you when there are issues. Already got me thinking I might want to go...

I ended up buying this one from surplus center, matches pretty close to the jct motor. https://www.surpluscenter.com/Hydraulics/Hydraulic-Motors/Low-Speed-High-Torque-Hydraulic-Motors/24-36-cu-in-rev-Danfoss-355400AH321BAAAAP-Hydraulic-Motor-11200557-9-16012.axd

Yes I still have it. Not for sure what they call it but the shaft inside the motor was broken. This is a new tiller never used, my guess the motor broke when they tested it at the factory. Its doubtful I will hear from JCT or that they will warrantee the motor but I would like to hold onto it...

thanks I was able to find a motor that should work.

I have a JCT tiller and the motor is bad, I am not having any luck finding a replacement motor. Jct will not reply to my email, that is the only to contact them. Anybody know of a good place to find a motor that will work. From what I can find this motor is a hmsj-400 specs below.