Recent content by ddsprint

looking for v 1702 flywheel and fly wheel coupler bolted to it, thank you

Typically it would be leaking, at the control valve, the tilt spool, but if not knowing after 20 years of life, if it was rebuilt or not, if not it’s worn out, most likely, they become swelled up over the years don’t hold position over time and eventually start leaking

When starting the machine

When the engine is out see if the pump even turns, somehow the pump seems to be locked up, I would crack the lines and see if there is some sort of air lock

i got it printed, thank you very much Sir

thank you

try [email protected] i not real familiar with it, so let me know if it goes through, thank you

[email protected] Thank you

i need a little help, my service manual only covers gresson pump, and i have a 4 spool unit, it's called melroe 700 series, 800 serials, it says it's in the component manual, no problem, but the problem is i can't find one, so if anyone can steer me in the right direction, it would be greatly...

it is a new cap as of last summer and it is doing it's job, thanx, So when is a primer fuel ball shot, last one sucked tight time and time again and put one in that had in tool box, still has suction so put it in and it is doing the same thing,

Looking for some input here, put a new fuel pump on, primer bulb collapses, put a new in tank line and a one way screen in tank, ran better although with about 30 min use, primer bulb collapses, by pass fuel filter and samething, so what is it that I'm missing in this puzzle here, All inputs...

if the machine sit a week or so, needs to be pumped first, doesn't seem to keep the ball pumped up and stay there, so is it the ball or the lines or both, You can pump it up, but doesn't seem to stay there, looking for a few thoughts, thanx

flip the cab up and starting moving the levers, until U find which one it is, it is either the front one or the back, 9/16 wrench or rachet and loosen a tad and change the adjustment just so slighty and check go one way or the other, this is what U do to adjust, although the reality is that even...

So tell me this, is there anyway to test a lift pump, my machine dies after running, pump and runs for a bit and dies again, have already blown out lines and flushed tank 3 times, bobcat dealer says lift pump or injector pump, the injectors are new and rebuild, thanx for all input,

when u turn over the engine crack the line open on the first injector while turning over this push the air out and when fuel starts pushing out close and go to next if necessary it will start try that,