Recent content by ckjohnson99

I have brackets that mounted on my Bobcat 763H for a Bradco 8511X hoe. I can't find the part numbers on them; perhaps you could inquire to see if they might fit.

I have a set of brackets that were used to mount a Bradco 511 hoe to a Bobcat 763H. I've since gotten a new machine and had to purchase different mounting brackets. I don't know where to look to see what the part numbers of these brackets are or if they will fit other hoe/machine combinations...

I purchases a Bradco 511 probably 15 years ago when I bought my first Bobcat 763. This attachment requires special mounting brackets sized for the particular machine you are using and they aren't cheap. However, the hoe is very well built. I've used it to put in 200' of water line (8 feet deep)...

Everything is working fine then we started to get fuel spraying from a pinhole leak in one of the two inch rubber lines that feed return fuel from the injectors into the return fuel harness. OK, replace the short line and another pinhole leak starts on another line. Purchase the hole return fuel...

My S595 has been working wonderfully with my Bobcat snowblower. However, starting just last week, the middle thumb control on the left steer arm got sticky and within one or two uses, it became frozen in place. That switch controls the direction of the snowblower chute so its important. As a...

My two speed S595 seems to want to veer slightly left when both arms are fully forward. In order to go in a straight line (down the road to the neighbor's place), I have to hold the right arm slightly back which slows the machine down. Is there an adjustment somewhere that I'm missing?

I recently upgraded my old Bobcat 763 to an S595. Unfortunately, I didn't think to investigate the cost of new brackets to get my Bradco 511 backhoe working again. Thru the dealer, the Bradco brackets are (hoe) $2100 plus (Bobcat) $215! Anyone want my old brackets?