Hi All
The valve block on my Bobcat X125 is cracked and leaking out past one of the 4 bolts, I thought it was the rubber O rings but after changing its still the same
Does anybody know where I could source one of these, I've attached pictures to show
Thanks
Hi All
I have a year 1989 Bobcat X125 and the copper ring is leaking hydraulic fluid at travel motor valve block
Does anyone know the correct size for the copper washer?
The closest I can get is M18 but it wont go over the threads on the bolt
Hi All I have a bobcat X125 digger which has a problem on the pilot pressure valve which has an accumulator fitted The problem is the hat shaped plate that goes under the spring that regulates the pressure is damaged Is it possible to buy this part ?
Hi All I found the problem The metal plate that splits the 2 sides of the mains block had cracked and broken at the top hole I'm going to get this made a t local metal works , is it OK to use standard plate metal of the same thickness ?
Hi All I have a bobcat X125 mini digger with a problem with the hydraulics There is no pressure on the pilot system or at either end of the main valve body until the AUX hammer pedal is pressed Once the Aux pedal is pressed everything works as normal but the engine is under load as there is full...
Hi Tazza When the engine starts in bogging down, it will not rev until the hand controls are moved to release the pressure feels like the pump is under too much pressure The machine will go forward OK when both levers are pressed but when only one is pushed forward the track will barely move...
Hi Tazza I finally managed to locate the filter inside the hydraulic oil tank which was badly blocked. Where the return filter should be theirs nothing there, its been removed by someone I cleaned the filter thats down inside the tank and refitted but the digger still does nothing until the...
Hi All I have an old Bobcat X125 mini digger which is doing its movements in slow motion Left to right is very slow and lifting the boom up and down is the same The digger will only work when the double speed pedal is pressed Would there be a faulty valve somewhere ?