Recent content by Cederbergb

i have messaged them .but they must not participate in the forum outside of buisiness hrs.ill probly have it all rigged before they ever respond.lol

have t550 with 14 pin kit already installed .can i buy a harness to run two seperate 12 volt linear motors off the aux switches

Update on hyd problems .had to replace right handle works fine now.

I was just going to hook up lines on a home fabed broom and was wondering if I need any special valves to protect drive motor.or is speed slow enough to to just shut off and reverse without any extra relief valve

I have been searching for info on the right handle and swithes and nothing comes up on the subject.can i just pull apart handle and replace the trigger switch or do i have to buy the whole handle.and where can i find any repair parts or instuctions.

Trying to run a digger with thumb on it and the aux stops working after a couple minutes.shut machine off and restart and it works for couple minutes and shuts off again.code shows h1222 right switch limit low.any ideas?

T550 aux hyd kick out and get h1 222 code. Any suggestions as to what would cause this?trigger switch for does not do anything either.using an attachment with a thumb and will work for couple minutes then quits untill shut of and restart.