Recent content by ccaissie

Help Support SkidSteer Forum:

  1. ccaissie

    Where is serial number on a Mustang 940E?

    Nice machine, looking to set up a maintenance program on the farm, need serial number so I can reference parts, manuals specs and all that. looked all over, couldn't find a number anywhere.... Appreciated!
  2. ccaissie

    Bobcat T190 Bad cylinder?

    Checked compression...about even while cranking 280-300psi. So basic engine ok. Kubota V2003T Back to the issue I had earlier when I accidentally moved Cylinder #1 injection assembly on the pump. It turned, and then didn't deliver fuel, so I turned it back to where I could detect contact marks...
  3. ccaissie

    Bobcat T190 Bad cylinder?

    Replaced head, ran fine. Now cylinder #2 (where the original crack failure in the head was, coincidentally) reported to be misfiring, killing the power, smoking, and hard to start. When the head was off, the cylinders all looked good, no scoring, very little wear/ridge. cleaned up well, and...
  4. ccaissie

    T-190 Kubota VT2003 runs, no fuel at #1 cylinder pump outlet

    Actually when I was removing the injection lines, I noticed the clamp holding the #!,2 outlet assemblies was loose and when I tried to break loose the line fitting on #1, the outlet assembly turned. Could that have caused it? Is that an adjustment? I see it has some serrated teeth to lock...
  5. ccaissie

    T-190 Kubota VT2003 runs, no fuel at #1 cylinder pump outlet

    Replaced head, started, runs on 3 cylinders. Cracked #1 injector line (starboard side) at pump, no fuel pulses there. What can be the cause of this pump failure... There was no interference of the pump parts. I have the service manuals, and am prepared to open the top of the pump if necessary. C
  6. ccaissie

    New to Forum, T190 bobcat needs headgasket and more

    yah, older...It's definitely not a 2007
  7. ccaissie

    New to Forum, T190 bobcat needs headgasket and more

    OK. I did remove head, #2 full of coolant, crack in the #2 Head right at the precombustion chamber insert. This head is a rebuild judging by the machine marks on the deck...not the original pattern. Bobcat service guys said check the piston height Re: bent stuff and change oil 3x after...
  8. ccaissie

    New to Forum, T190 bobcat needs headgasket and more

    Beginning a teardown for a client on a Bobcat t190 Serial # 519314690. Was out on loan, wouldn't start, many attempts, was found with mayonnaise in the crankcase..was drained asap. Was told the head replaced not too long ago..old one was cracked... Would you guys pull the head and assess the...
Top