Recent content by catmanjan

Help Support SkidSteer Forum:

  1. catmanjan

    Lift slow and eventually stops as machine warms up

    Alright I wasn't able to tee into anything else, the tee I have is a 3/4 JIC which seems to only fit into the lift cylinders... I have both reliefs off at the moment, I noticed a piece missing from the main relief (I think) - see below the CLYD RING is missing https://imgur.com/a/96meDCF Also...
  2. catmanjan

    Lift slow and eventually stops as machine warms up

    Thanks for the reply, I'll see if I can fit it anywhere Is there anything I can do to rule out aux hydraulics? e.g. if I disconnect the aux solenoids does that mean it can't be aux? Which relief should I be focussing on? I have a main relief and a port relief
  3. catmanjan

    Lift slow and eventually stops as machine warms up

    Bobcat 753G I've been trying to diagnose this one for a while, I have a pressure valve on a tee on the retraction side of the lift boom With the machine cold, I get 2100 PSI at idle and 2500 PSI full throttle With the machine warm, I get around 1100 PSI at idle and 1500 PSI at full throttle -...
  4. catmanjan

    Removing kanga engine?

    I just bought a kanga that needs new rings, what's the best way to get the engine out? I can see the engine is mounted on a plate which is then bolted to the chassis Should I remove the plate and engine all in one or take the engine off the plate and leave the plate attached to the chassis?
See more
Top