Recent content by buckwheat_la

did you change one pump already? there are two set/control screws that can help you set it so it works properly.

some wear from the holes in the pump mounting. I had the holes machined back to the proper size, then to give it a little more stength, we also welded a piece on the exact edge of the pump to give it some strength by giving it something to hold it from the torque. This is a bit unproven as we...

So we figured out what was going on with the hydraulic pump shering bolts all the time, and have dealt with it. While dealing with it, we found that the rear pump gasket was leaking, so I figured since it was out we should do that repair too. We took the back shaft out, and replace this gasket...

The motor mounts seem fine. I agree with you that it seems to be a alignment issue, but it is sitting properly on the spline, and the mounting plate seems to be square too. Now that mounting plate had a little wear in it, but we had it filled in and machined flat again, so I am really not...

So I am a new poster here, my shop does all its own repairs on our equipment, which is mainly skidsteers and loaders. So we have a 1840 from 1996, and this unit seems to have a problem that no one can explain. It keeps shearing off the bolts that hold the pump to the flywheel. We have replaced...