Recent content by BOBCAT610

had rusted out vacuum going to guage in intsterment panel

put new pump in still not fully cured. any help apreciated.

i am getting a lot of foam in the hydraukic tank.i think it is the pump. any help. should i put a rebuild kit in or new pump?

no they are not. i checked the master release valve and the clutch release valve. also the aux hydrolics don't work well

got the boging of the engine fixed. still has the hydroilic issue when you try to raise the boom or tilt it will raise a little then stop. let off the pedal and push again it willraise a little more.

just bought a 610 myself. it came with a service manual. the service manual has very good instructions and diagrams on most of the repairs. i have to do a front seal on mine.

looking for a used one. just bought a 610 with the backhoe attatchment. some one previosly unhooked the hydrolic line and has cobed it tohether wirh a bolt and nut tohold the outer sheave on.

i am going to start with fixing all the leaky cylinders

just lift and tilt the drive system is not hydrolic

i have a bob cat 610 just the other day the hydrolics started acting up. when i raise or tilt the bucket is bogs down the motor. let off the control and the motor revs back up then it does it again when i attempt it again. changed the fluid and filter and have the same issues. any help appreciated.