Mine is falling under the IInd cader, No power at 1 of the term(red) out of the three (red, white, black) whereas there is power at both red n white before the timer pigtail (checked fuse, its intact) so i suspect the timer is bad. Planning to replace it tomorrow, its a 156 C$ insanely priced.
Hey Folks, My 463 skidsteer doesnt start, randomly starts after 10 or so cranks. Once starts runs fine, I put new primer bulb. I checked the fuel line inside the tank & didnt find a pick up filter/ oneway valve inside it was just a open end tube. I removed fuel line before the fuel pump & it had...
Hey Varvel, I have the same model, a work horse. Check those white plastic /metal sliders under the lap bar fully engages/ disengages, other than that i can only think to check those wires behind the bics to make sure its not chewed or something. pls report back. Thanks.
Hello Folks, I have this rough running engine, as if going to die when its on load during digging etc, goes away & comes back occasionally. I just replaced Fuel filter, cleaned air filter, cleaned out the soot at the muffler by closing the exhaust while Square nut was open. that relatively new...
Hey Folks, Looking for some advice or improvement suggestions for my Bobcat324, the Control lock sensor clearance when console is seated for operation seem to have developed some spacing on both sides due to the roller bearing wear out...i did replace bearing on one side of the console which...