Recent content by 94BC743

Should be located on the 'front side' of the block, towards the top. Front being the side closest to the loader. Right side if sitting in the machine. If you follow your lines for your cab heater it should bring almost right to it. Single purple wire running from it to the wiring harness.

Point taken, I have added a few washers to the brake pedal to get some more throw out of the pedal. Now to the neutral on my pump. The machine doesn't creep at all when warm and will stay put with no issues. It is just when its cold that it will start to creep until it gets a little bit run...

Hello all, I have been using my 94 743B quite extensively this year for snow removal. And have found a few flaws of using this particular machine. The biggest fear of mine is it "walking" away while i'm letting it warm up. When it is really cold the machine has a tendency to creep forward and...

Hello all, After getting a overheating issue fixed on my 1994 743B I have been using it more and have noticed a very loud whine. It only happens when using the left stick, both when turning forward or backwards. But, if I drive straight ahead or straight back no noise, I can use the right stick...

Update for this issue, I left the machine for a while and just recently started working with it. After looking at some parts diagrams I found what my inspection panels should look like in my blower housing and I had none. After replacing them all is good. Machine runs up to 170ish degrees and...

Hello all, Long time lurker here and finally made an account because I'm stumped. About a month ago I bought a 94 743B with 4500 ish hours. It needed a few hydraulic hoses and fuel return lines. I never really ran it for more then 1-2 minutes until about a week ago. The original temp sensor was...