Recent content by 277Bobcat

Help Support SkidSteer Forum:

  1. 2

    Code intake air temperature too high

    I wanted to post an update. Did a video consult with Brady with tetradgroup from YouTube HowIDidit. After having problems with fuel system and picking up the machine from the dealer, I have had this high air intake temp code. Turns out the boot to the air filter is missing. So the machine was...
  2. 2

    Code intake air temperature too high

    I looked for a crack or leak in exhaust in the engine compartment and see none. I did order a replacement air filter in case this is an issue. Bobcat says not to dust out the old filter. I have located the sensor with service manual. Is it worth pulling and cleaning the sensor? I'm sure there is...
  3. 2

    Code intake air temperature too high

    Bobcat T770 throwing code air inlet temp too high M1210. Machine engine temp is fine. I just had it in shop. Wondered if some part of exhaust was disconnected and leaking, but I don't feel any major leak in engine compartment. Anything else to check?
  4. 20240921_154856.jpg

    20240921_154856.jpg

  5. 20240921_153801.jpg

    20240921_153801.jpg

  6. 2

    Drain fuel tank T770

    I emailed bobcat parts and my specific serial # machine appears to have a fuel tank with no plug. That seems crazy to have no way to drain the tank via plug removal. Will use tips from above, thanks
  7. 2

    Drain fuel tank T770

    Thanks very much for the advice. I had water in fuel code and was wondering if I should just drain the tank, let fuel sit in clean container and then re add fuel above any water that settles out. Basically just trying to start over fresh. I just had to get a new fuel rail due to stuck open...
  8. 2

    Drain fuel tank T770

    Does anyone have experience draining a fuel tank on T770? Best to use transfer pump and then pump remainder out via the primer bulb? I do not think it has a drain plug?
  9. 2

    bobcat t770 code M3128

    Thank you for the suggestion. Will definitely check connections. I tested fuse with electrical meter tester but I did not check the connections
  10. 2

    bobcat t770 code M3128

    I have a T770 bobcat that had code for SCR temp sensor fault. The engine would run fine and then would go into low idle mode after about 30 to 40 minutes. I put some new DEF and DEF cleaner in hoping this would fix the problem. Was running the machine yesterday grub some small cedar trees and...
Top