Pickuptrck
Member
- Joined
- Aug 30, 2014
- Messages
- 17
Hello all, first post here so thank you for the knowledge base. I bought a 963g (year unknown just yet) she has BICS but no BOSS. that is blowing BICS fuses on power up. History: bought 2 weeks ago, ran fine as best as I could tell. ruptured a diagnostic hydraulic line and spewed fluid everywhere. Drained tank dry before I realized what happened only after losing drive, fluid trail everywhere I just was. Replaced the line, refilled, hosed engine bay down with garden hose to check for new leaks and cleaned the floor board pedal area of about 20 lbs of rocks and garbage ( no drain in the floor board???? Geniuses). Bics fuse then blows for the first time, no hydraulic movement. throw in a new one, finish idling to purge air, BICS shows all green lights (I do not have a seat light on mine and all lights lit in series as they were supposed to prior to BICS Troubles) backed up and started to scrape dirt/fill bucket for about 20 seconds. BICS blows fuse second time and now blows at power on every time. Attempted fixes: Seperated EVERY electrical connection I could find, sprayed with electrical clearer. Covered rubber seal with dielectric grease (not any pins). Applied power to aluminum block in engine bay at front most area near where feet are and DID hear a click on the right hand plug (green and black wire on harness side). No response on left side. I assume that was at least one of the traction locks, no bucket or drive movement. Where do I begin? Thank you in advance. [email protected] 405-651-5897