Recent content by Kburroug

Check out www.repowerspecialist.com

I am referring to the chain sprocket on the drive motor. I measured the bore compared to the old sprocket and the taper is actually cut different. I am having a machinist atttempt to correct the taper. At the large end of the taper the diameter is correct however at the small end there is .075”...

Has anyone recently replaced the drive motor cluster sprockets on an older 632? I purchased two new sprokets however the new sprockets bore are .020” tighter than the old sprockets which will not allow the new sprocket to fully seat on the shaft. Any help is appreciated!

Too far away

Where are you located?

I just installed a cummins B3.3T in my 632. It looks just like your machine. I took the original fan drive plate and the new flywheel to a machine shop and had them cut the drive plate and drill new holes to match the new flywheel. When I purchased the 632 someone had swapped in the isuzu...

I am running the original radiator with electric fans. The engine is a brand new ready to run unit from Cummins. It cost $3900.00

Hello All, I am new here. I have recently installed an 83hp Cummins B3.3T in my 632. Overkill I know but It only cost $200 more for the 83hp turbo engine versus the 60hp natural. I was wondering if it is possible to replace the 9gpm drive pump with a pump in the 15 to 20 gpm range.