Recent content by Delly

Anybody ? It's the lower boom bushing on the inside of the machine not the outside.

Hey guys, my 1997 lx565 bushing pushed out when I put grease in it, why is that? I replaced all the pins and bushings along with all new hardware last year. I went to grease the machine and when I grease the fitting I watched the bushing on the inside push out, the outer one was ok. So I tapped...

Hmmm Ya no Mike the more I look at picture number 1 I don't even think the hand control and box will fit back in there if that pipe was routed that way along the side of the gear box..

I replaced all the lines off the control valve. Everyone was a exact fit. These 2 are nowhere the same. The one line won't fit between the gearbox and a fat hydro line coming off the control valve, so today they called me after looking at all photos and agree there has to be a wrong part number...

Yes left side is the problem I'm having. These lines are so different from the originals that they won't work. I have a picture in the photos section if you could look at it for me Mike. I'm thinking they have the wrong part number on the parts site. Thanks.

IMG_1189.JPG

Ok I think I got a photo in that section under lx565 control valve hydro line. My original line is marked with blue tape so you can see the way it routes and the new one is there I'm pointing to them. Thx.

Hey guys I have the lx565 I'm replacing the 2 lines off the t fitting on the back of the control valve there's a 2 right and 2 left. Well I ordered them and the left side looks totally different they don't even follow correctly I'm trying to explain to messicks but they don't understand. Is it...

Just realized you told me already pins don't bottom out lol. Sry.

Ok so I think I have it correct. I would say 1/8" to 1/4" of movement on the plate side to side. I'll try the hammer method. Do you know the torque setting? The same movement on the bottom of the plate and boom is the same up where the piston slides into on the plate. I just don't remember that...

Hi guys, I replaced all my bushings and the 2 pins in the bucket area on the plate. I have the round tube plate. My question is why do I still have play there's about a 1/4" slop back and fourth. Is that normal for the plate attachment area and the same goes for the pistons on the bucket tilt...

Did you ever do the mod for the gear oil?