Hi guys, I replaced all my bushings and the 2 pins in the bucket area on the plate. I have the round tube plate. My question is why do I still have play there's about a 1/4" slop back and fourth. Is that normal for the plate attachment area and the same goes for the pistons on the bucket tilt and curl. I also replaced those bushings and pin slides. Am I suppose to have the bottom pins pressed in or slammed in with a sledge hammer? I can take the bolt washer and nut off and look inside there and see that the pin doesn't seat up tight in there, but I thought that was normal otherwise you wouldn't have anything to grab when you have to hammer them out. Any help would be great thx.