Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="Mike10" data-source="post: 46015" data-attributes="member: 5461">[FONT=Swiss721SWA,Bold]<div style="text-align: left">It takes a separate harness.  I think this might be the part number for the harness. Also, here is the instructions for the wiring.</div> <div style="text-align: left">WIPER/WASHER WIRE HARNESS</div> <div style="text-align: left">INSTALLATION</div>[/FONT]<div style="text-align: left">1. Disconnect the battery (-) negative ground</div><div style="text-align: left">cable, if not previously removed.</div><div style="text-align: left">2. Remove the cab side panel to access the</div><div style="text-align: left">service/run switch and fuse panel area by</div><div style="text-align: left">removing two bolts, 1. Open fuse block</div><div style="text-align: left">cover, 1, Figure 14.</div><div style="text-align: left">3. Route the 26</div>″ long end of the main power<div style="text-align: left">wire harness, reference 9, Figure 4, with the</div><div style="text-align: left">O/GY (orange/gray) connector and the B</div><div style="text-align: left">(black) flat hole-type connector through the</div><div style="text-align: left">cab at 2, to the fuse block area. Allow the</div><div style="text-align: left">remaining 44</div>″ section of the harness to hang<div style="text-align: left">in the right front corner of the cab at 3.</div><div style="text-align: left">4. Locate the single (O/GY) wire connector</div><div style="text-align: left">from the wiper 7.5 amp fuse and connect it to</div><div style="text-align: left">main power harness as shown at 1. Attach</div><div style="text-align: left">the black (B) ground wire on ground stud, 2.</div>[FONT=Swiss721SWA,Bold][FONT=Swiss721SWA,Bold]<div style="text-align: left">NOTE: When attaching ground wires,</div><div style="text-align: left">always place the heaviest ground wire</div><div style="text-align: left">next to the ground surface. Stack the</div><div style="text-align: left">remaining ground wires according to</div><div style="text-align: left">wire size or number of wires with the</div><div style="text-align: left">single spade connector with the largest</div><div style="text-align: left">first and the smallest on top.</div>[/FONT][/FONT]<div style="text-align: left">Reinstall the cab side panel previously</div>removed.</blockquote>

Verification