Reply to thread

Message: <blockquote data-quote="mikel" data-source="post: 23199" data-attributes="member: 1994"><p>Cold isn't a problem as it isn't too bad round here. To restate the problem, for a while after starting the engine, I have no hydraulic power - it usually takes nearly 10 minutes for it to come on. Both rocker switches should show green when working normally and red when switched to 'safe mode'. When the problems occur, only the switch controlling the boom is green, the switch that works the wheel brake is not illuminated even though it is in the 'on' position. It illuminates when hydraulic power is restored. Occasionally during use it darks out for a minute or two also - most annoying! Anyway, rang up a dealer and he suggested that the source of problem lies with the control module and advised replacing it (and in fairness they have a lot of experience with these). Not too difficult to swap out but cost of thing could run to nearly 500 euro. Anyway of proving that the problem is with this module? Any way of patching up existing module? TIA, Mike.</p></blockquote><p></p>