Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 62482" data-attributes="member: 82">This machine i suspect is just for farm/home use, i'd just flatten the wear plates like you were going to and not replace the rotating group, just give it a good clean. I put together a pump for a mad mate that had end play like that, i have not yet started the machine, still a few months off being ready for that.As you already know, the cast iron may take a little longer to sand down, you may alwo want to do the surface of the rotating group too, ensure there are no marks on it.</blockquote>