u joint

[renopker]

Any body have a spicer P# for the hyd coupling u joints? (642-743) If not Ill post it when I find it.

 

[jerry]

When I replaced mine on the 632 I used Bobcat parts because the others I found greased in the center of the cross rather than out on the end which is a lot easier to access. Bobcat parts were about the same price also. But things may have changed in two years.

 

[Tazza]

When I replaced mine on the 632 I used Bobcat parts because the others I found greased in the center of the cross rather than out on the end which is a lot easier to access. Bobcat parts were about the same price also. But things may have changed in two years.

I have the numbers written down at home. As Jerry said, the bobcat ones have better greasing points. Not sure how the price from bobcat vs aftermarket was though.

 

[renopker]

I have the numbers written down at home. As Jerry said, the bobcat ones have better greasing points. Not sure how the price from bobcat vs aftermarket was though.

I found the part # for the NAPA but there more then bobcat Napa is always high even with the discount.If I get to Dana #s I can get jobber price.

 

[Tazza]

I found the part # for the NAPA but there more then bobcat Napa is always high even with the discount.If I get to Dana #s I can get jobber price.

I can't remember the brand i got, but they were made in the USA, all i remember is they were quality, and the price was rite too. I *think* they were about $50 each AUD.