Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tree and brush puller. Now the welding.......
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="perry" data-source="post: 19667" data-attributes="member: 538"><p>Mike, I tried to visualize your instructions, but little success except for the pin idea which I like. Did plan to cut each end of the turn buckle at 45 degrees, then mill flat area on the upper pivot and lower tooth bar. That would give me flat surfaces to weld on. The upper pivot is 4" diameter and the tooth round bar is 3", the turn buckle threaded ends are 1 1/2" diameter.</p></blockquote><p></p>
[QUOTE="perry, post: 19667, member: 538"] Mike, I tried to visualize your instructions, but little success except for the pin idea which I like. Did plan to cut each end of the turn buckle at 45 degrees, then mill flat area on the upper pivot and lower tooth bar. That would give me flat surfaces to weld on. The upper pivot is 4” diameter and the tooth round bar is 3”, the turn buckle threaded ends are 1 1/2” diameter. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tree and brush puller. Now the welding.......
Top