Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tree and brush puller. Now the welding.......
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mllud" data-source="post: 19666" data-attributes="member: 1012"><p>Perry</p><p>On end of the turnbuckle that attaches to the push bar could have a square plate welded to the end the same thickness as the turnbuckle bar. [3x3inches X 1 inch thick,with a hole through in it for a pin.</p><p>Then weld a piece like you built for the end of your brackets {the triangle with a hole thru it} to the back edge of your round push bar.Where you want the turnbuckle to attach.Then the flat end you welded to the turnbuckle would go flat against that to the inside.Weld another bracket on the push bar on other side of the flat end. A pin would go thru all three pieces.</p><p>The uprights on a three point hitch have a u shaped end that straddles the lift bars With a pin to attach.</p><p>That could be a way to attach to your mounting plate. The u shaped end could be welded on the turnbuckle and straddle a bracket welded on the mounting plate.</p><p>I typed this out once and it got lost in GIGAspace and it really BITES. This is another sleepless night so take that into consideration.I could have dreamed this whole thing up. Mike</p></blockquote><p></p>
[QUOTE="mllud, post: 19666, member: 1012"] Perry On end of the turnbuckle that attaches to the push bar could have a square plate welded to the end the same thickness as the turnbuckle bar. [3x3inches X 1 inch thick,with a hole through in it for a pin. Then weld a piece like you built for the end of your brackets {the triangle with a hole thru it} to the back edge of your round push bar.Where you want the turnbuckle to attach.Then the flat end you welded to the turnbuckle would go flat against that to the inside.Weld another bracket on the push bar on other side of the flat end. A pin would go thru all three pieces. The uprights on a three point hitch have a u shaped end that straddles the lift bars With a pin to attach. That could be a way to attach to your mounting plate. The u shaped end could be welded on the turnbuckle and straddle a bracket welded on the mounting plate. I typed this out once and it got lost in GIGAspace and it really BITES. This is another sleepless night so take that into consideration.I could have dreamed this whole thing up. Mike [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tree and brush puller. Now the welding.......
Top