Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Takeuchi Skidsteer Forum
TL130 Won't charge, blinking battery light
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Hermie" data-source="post: 94220" data-attributes="member: 13413"><p>Thanks for looking into this. The relay is in the starter circuit and disengages the starter when the engine rpm gets high enough. I wish I had known that before I bought a new one!</p><p>Yes, I am getting battery voltage at the IG terminal while it is disconnected. One thing I've noticed is that the other terminal (L) just goes through the charge lamp to ACC(which is also connected to IG). When I measure resistance from L to ACC, Instead of seeing a 40 ohm (3.5W) lamp, I see 2Megaohms 1 direction and infinite other direction, so I hooked up the diode tester, and I see a 1V diode drop on that circuit.</p><p></p><p>What I'm in the middle of now is just putting a new lamp directly from L to IG, bypassing whatever other circuit was on L. If that is a bad idea, please tell me now!</p></blockquote><p></p>
[QUOTE="Hermie, post: 94220, member: 13413"] Thanks for looking into this. The relay is in the starter circuit and disengages the starter when the engine rpm gets high enough. I wish I had known that before I bought a new one! Yes, I am getting battery voltage at the IG terminal while it is disconnected. One thing I've noticed is that the other terminal (L) just goes through the charge lamp to ACC(which is also connected to IG). When I measure resistance from L to ACC, Instead of seeing a 40 ohm (3.5W) lamp, I see 2Megaohms 1 direction and infinite other direction, so I hooked up the diode tester, and I see a 1V diode drop on that circuit. What I'm in the middle of now is just putting a new lamp directly from L to IG, bypassing whatever other circuit was on L. If that is a bad idea, please tell me now! [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Takeuchi Skidsteer Forum
TL130 Won't charge, blinking battery light
Top