Reply to thread

Message: <blockquote data-quote="skidsteer.ca" data-source="post: 2569" data-attributes="member: 307"><p>I've usually let the machine shop weld these, as you have to be careful to weld equal amounts around the shaft , so that the weld "pulls" equal amounts and you end up with a rod end that is purpendicular to the ram centerline. But if you you "screw up" just cut it off and try again. Generally I try not to get the chrome to hot. Just weld one pass and let it sit for a few minutes. I don't usually at much extra water right after weld, but dampen the rag again each time before I start, after it has had say five mins to cool. I've only done a few times , but have never had one I felt i needed to remove. Ken</p></blockquote><p></p>