Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tilt problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Bobpuddy" data-source="post: 15881" data-attributes="member: 1762"><p>I checked my chain case and it was way low, so I ran a hose from the hyd tank down to the chain case and siphoned them to the correct level. With the tilt problem, I checked the steer arm and it was returning to center as it should. Also I inspected the tilt operation more closely. I noticed that with the boom raised to almost full height, when I tilted the bucket down, it seems to go down with hyd pressure then suddenly swing freely once it reaches straight down position. It acts as though the cylinder extends to far. Is it possible that a stop inside the cylinder has broken? What controls how far the cylinder extends? The bucket swings so far that the fluid line gets pinched between the cylider and the brace under the cylinder.</p></blockquote><p></p>
[QUOTE="Bobpuddy, post: 15881, member: 1762"] I checked my chain case and it was way low, so I ran a hose from the hyd tank down to the chain case and siphoned them to the correct level. With the tilt problem, I checked the steer arm and it was returning to center as it should. Also I inspected the tilt operation more closely. I noticed that with the boom raised to almost full height, when I tilted the bucket down, it seems to go down with hyd pressure then suddenly swing freely once it reaches straight down position. It acts as though the cylinder extends to far. Is it possible that a stop inside the cylinder has broken? What controls how far the cylinder extends? The bucket swings so far that the fluid line gets pinched between the cylider and the brace under the cylinder. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Tilt problem
Top
