Tilt Cylinder

[jcaldar]

Hey Guys newbie here. I have a 93 bobcat 853 and I changed the tilt cylinder seal kit on it and it seem fine no leaks. But now that I have changed the seals I notice that the my bucket tilts down on its own each and every time. Was I suppose to bleed the the Hydraulic lines? Not sure what to do, but I do know that this is a pain in my ass and how friggin annoying! Help Please anyone! John

 

[Tazza]

Just keep using it to get the air out, shouldn't take too long.
How fast is the bucket dropping? Are you sure the piston seal wasn't damaged during installation? Was it doing this before? were there any scratches in the bore? Was the piston nut done up tight?
Its a common problem where the load check seals go on the control block, it causes the lift arms or tilt cylinder to drop down on its own.