Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
tilt cylinder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="thetool" data-source="post: 17864" data-attributes="member: 1534"><p>Tazza-I"ll bet you nailed it. </p><p>On the front of your control valve there are ports that a port relief cartridge screws into. For your tilt circuit, it is a cartridge on the center port, if it has one. There was a rash of failures where the poppet would snap off and travel through the system, and I often the piece in the rod end of the cylinder! This is what could have jammed your cylinder in the first place.</p><p>Pull that cartridge and see if something looks broken off and missing form the end. Pull another to check it against, pull them all in case I'm confused about which port it may be in, but I'll bet you find a broken one, the port relief for rod end of the tilt circuit, and your flow is bypassing inside your valve.</p></blockquote><p></p>
[QUOTE="thetool, post: 17864, member: 1534"] Tazza-I”ll bet you nailed it. On the front of your control valve there are ports that a port relief cartridge screws into. For your tilt circuit, it is a cartridge on the center port, if it has one. There was a rash of failures where the poppet would snap off and travel through the system, and I often the piece in the rod end of the cylinder! This is what could have jammed your cylinder in the first place. Pull that cartridge and see if something looks broken off and missing form the end. Pull another to check it against, pull them all in case I'm confused about which port it may be in, but I'll bet you find a broken one, the port relief for rod end of the tilt circuit, and your flow is bypassing inside your valve. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
tilt cylinder
Top
