Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
tilt cylinder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 17838" data-attributes="member: 82"><p>It sounds like the piston is sitting too far back causing the piston to block the inlet port of the ram, this will make it so you have to put force on the bucket to pull the stick forward to let the oil in to get past the inlet hole then its ok till you fully retract it again.</p><p>Did you pull the ram apart? i'm just wondering if the piston is the wrong way around causing it to cover the inlet port.</p><p>The hour metre clicking over is electrical, the pedal should have nothing to do with it ticking over.</p><p>Air in the system will cause jittery operation but not for it to stick.</p><p>Keep at it, you'll get it sorted out! I'd offer to help you out over the phone, but i live a little too far away! unless you have MSN messenger.</p><p>Don't let it beat you!</p></blockquote><p></p>
[QUOTE="Tazza, post: 17838, member: 82"] It sounds like the piston is sitting too far back causing the piston to block the inlet port of the ram, this will make it so you have to put force on the bucket to pull the stick forward to let the oil in to get past the inlet hole then its ok till you fully retract it again. Did you pull the ram apart? i'm just wondering if the piston is the wrong way around causing it to cover the inlet port. The hour metre clicking over is electrical, the pedal should have nothing to do with it ticking over. Air in the system will cause jittery operation but not for it to stick. Keep at it, you'll get it sorted out! I'd offer to help you out over the phone, but i live a little too far away! unless you have MSN messenger. Don't let it beat you! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
tilt cylinder
Top