Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 17528" data-attributes="member: 82">The 763 cylinder i measured was 1/2" longer than the 743. The part numbers for the tilt cylinders for a 743, 751 and 763 are all different.... At a glance they are the same, but lengths seem a little different and the gland nut is shorter in the 751 so stroke will be longer than the 743 and 763. They also run different pistons! Minor differences on the outside too, like a stud welded to hold the tube line instead of a clamp.Long story short, they are not interchangeable but i believe if you spent the time to change the pivot point on the bobtach you could get them to work as long as your stops were also adjusted correctly to prevent over tilting and possible ram stick bending.</blockquote>