Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
ASV / Terex Skidsteer Forum
TEREX PT100G loss of communication between Display and Main Controller
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="martinoamy" data-source="post: 120984" data-attributes="member: 22065"><p>Any one 'suffer' from this?</p><p></p><p> I have checked the 120 ohm terminators on ends of each Can bus. </p><p></p><p>I have Can bus 0 and Can bus 1. Each have 2 terminators. Found the ones near the controllers to both be bad.</p><p></p><p>The way you tell on CB 0 is ohm between 3&4 pin at display should be 60 ohm.</p><p>120 ohms means one terminator bad. 0 ohm both bad.</p><p></p><p>Thought I would have it fixed with new terminators. Ohms are 60 at display but still have 'Loss of Communication between Display and Main Controller'.</p><p></p><p>I have not taken controllers out and check connections there. Will do today.</p><p></p><p>Any ideas?</p></blockquote><p></p>
[QUOTE="martinoamy, post: 120984, member: 22065"] Any one ‘suffer’ from this? I have checked the 120 ohm terminators on ends of each Can bus. I have Can bus 0 and Can bus 1. Each have 2 terminators. Found the ones near the controllers to both be bad. The way you tell on CB 0 is ohm between 3&4 pin at display should be 60 ohm. 120 ohms means one terminator bad. 0 ohm both bad. Thought I would have it fixed with new terminators. Ohms are 60 at display but still have ‘Loss of Communication between Display and Main Controller’. I have not taken controllers out and check connections there. Will do today. Any ideas? [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
ASV / Terex Skidsteer Forum
TEREX PT100G loss of communication between Display and Main Controller
Top