Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T740 drive belt tensioner alignment
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jovol" data-source="post: 134607" data-attributes="member: 17669"><p>Hey, I recently acquired a 2018 t740. First issue I noticed was the fuel sensor was broken. Dove into the machine and found out it's because half the drive belt separated and took out the fuel sender electrical harness. So I ordered a new belt and tensioner wheel since there was play in the bearings and wear on the wheel's OD. I have it all back together, and I'm a little confused because the belt isn't lining up with the wheel. I don't know if it's supposed to be like this or not, the parts diagram nor the service manual show a good view of it. Here's how mine looks:</p><p>[ATTACH]6523[/ATTACH]</p><p>Notice how the wheel is offset to the left of the belt, and a small portion of the belt is hanging off the right side of the wheel. Perhaps it's supposed to be like that? But if it's not it probably contributed to the old belt breaking. Anyone have experience with this and know if it's messed up?</p><p></p><p>Thanks,</p><p>John</p></blockquote><p></p>
[QUOTE="jovol, post: 134607, member: 17669"] Hey, I recently acquired a 2018 t740. First issue I noticed was the fuel sensor was broken. Dove into the machine and found out it's because half the drive belt separated and took out the fuel sender electrical harness. So I ordered a new belt and tensioner wheel since there was play in the bearings and wear on the wheel's OD. I have it all back together, and I'm a little confused because the belt isn't lining up with the wheel. I don't know if it's supposed to be like this or not, the parts diagram nor the service manual show a good view of it. Here's how mine looks: [ATTACH]6523[/ATTACH] Notice how the wheel is offset to the left of the belt, and a small portion of the belt is hanging off the right side of the wheel. Perhaps it's supposed to be like that? But if it's not it probably contributed to the old belt breaking. Anyone have experience with this and know if it's messed up? Thanks, John [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T740 drive belt tensioner alignment
Top