Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T595 bucket won't lift load - low pressure?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="repriebe" data-source="post: 128424" data-attributes="member: 23619"><p>Hey everyone! I'm a newbie here, and I am having a problem with a T595. The bucket will only lift with the engine at full throttle, and even then, will not lift a load. When it goes up, it will hold and not go down until "told" to do so. The drive seems to work ok, but maybe slower than usual. I checked the drive belt and tensioner. On the gauge, the hydraulic pressure is pretty low (not in the red, but close at low engine speed). Wondering what it should normally read, and if anyone has any obvious things that would cause this problem. The one picture shows hydraulic pressure (top left gauge) at low RPM, and the other at high RPM (both with no load). Any help is appreciated. I was able to get to the actual readout as to the hydraulic system psi. Is 392 psi at 2336 rpm low? Any help is appreciated!</p><p>THANKS!</p></blockquote><p></p>
[QUOTE="repriebe, post: 128424, member: 23619"] Hey everyone! I'm a newbie here, and I am having a problem with a T595. The bucket will only lift with the engine at full throttle, and even then, will not lift a load. When it goes up, it will hold and not go down until "told" to do so. The drive seems to work ok, but maybe slower than usual. I checked the drive belt and tensioner. On the gauge, the hydraulic pressure is pretty low (not in the red, but close at low engine speed). Wondering what it should normally read, and if anyone has any obvious things that would cause this problem. The one picture shows hydraulic pressure (top left gauge) at low RPM, and the other at high RPM (both with no load). Any help is appreciated. I was able to get to the actual readout as to the hydraulic system psi. Is 392 psi at 2336 rpm low? Any help is appreciated! THANKS! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T595 bucket won't lift load - low pressure?
Top
