Hello, i removed the damaged sleeve and figured i could freeze shrink the new one to install but the sleeve was still to tight .
I used liquid n.
It felt like if i could tap the sleeve in while shrunk the sleeve would seat?
But i would have to remove engine in order to get the clearance for a hammer tap.
The shop manual will be here in a couple days.
Am i right in that i need to pull the engine in order to replace the sleeve?
I used liquid n.
It felt like if i could tap the sleeve in while shrunk the sleeve would seat?
But i would have to remove engine in order to get the clearance for a hammer tap.
The shop manual will be here in a couple days.
Am i right in that i need to pull the engine in order to replace the sleeve?