tbrouillard
New member
- Joined
- Jul 15, 2022
- Messages
- 1
I have a 2017 T590 bobcat. Long story short, I got it buried in mud, got it out, replaced gas, tested injectors, cleaned it out etc.
I got the engine running, however it was giving me low oil pressure. I changed the oil again for 15w40 in lieu of the 10w30.
Prior to the change when I had it running before it shut down, I engaged the hydraulics.
After changing the oil, the starter would not spin the flywheel. It would engage and just head up the wires. Starter is good.
I removed the starter and tried to turn the flywheel by hand. I removed the belt and it will not move. Not even with a pry bar.
Engine is Kubota 2607
Any thoughts on what the issue could be?
I got the engine running, however it was giving me low oil pressure. I changed the oil again for 15w40 in lieu of the 10w30.
Prior to the change when I had it running before it shut down, I engaged the hydraulics.
After changing the oil, the starter would not spin the flywheel. It would engage and just head up the wires. Starter is good.
I removed the starter and tried to turn the flywheel by hand. I removed the belt and it will not move. Not even with a pry bar.
Engine is Kubota 2607
Any thoughts on what the issue could be?