Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T190 New Owner Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="tnfarm" data-source="post: 33093" data-attributes="member: 3598"><p>I just bought a used T190 with 1080 hours. Used it approximately 20 hours and it was working fine when shut down at the end of the day. The next evening when i cranked it up within 20 seconds a continuous alarm sounded and a light noted overheat coolant but no code. I came back the next morning cranked the engine, no coolant code, alarm or light but within 30 seconds the hydraulic alarm sounded with a light and three repeated beeps. Talked with the dealer and they seemed to think the computer needed re-programed. Any thoughts or ideas, i usually do my own maintenance but this is very unusual. I have in the past disconnected the battery on my car to reset the computer, do you think this would work on the Bobcat? Thanks Tnfarm</p></blockquote><p></p>
[QUOTE="tnfarm, post: 33093, member: 3598"] I just bought a used T190 with 1080 hours. Used it approximately 20 hours and it was working fine when shut down at the end of the day. The next evening when i cranked it up within 20 seconds a continuous alarm sounded and a light noted overheat coolant but no code. I came back the next morning cranked the engine, no coolant code, alarm or light but within 30 seconds the hydraulic alarm sounded with a light and three repeated beeps. Talked with the dealer and they seemed to think the computer needed re-programed. Any thoughts or ideas, i usually do my own maintenance but this is very unusual. I have in the past disconnected the battery on my car to reset the computer, do you think this would work on the Bobcat? Thanks Tnfarm [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
T190 New Owner Problem
Top