Bobby the T190
Active member
- Joined
- Dec 1, 2022
- Messages
- 28
Recently picked up a T190 to run my BrushShark on.
Recently cleared about 1/4 mile of trail through heavy brush and small trees. Anything 4", and several of them at a time, or smaller that would fit between the teeth was cut with ease. Even cut a couple up to 8" by taking several bites around the perimeter until the final cut hit that 4" mark an slide all the into the cutting slot.
Ran into one issue when I ran the track up against a tree and forced it off the track. After a quick YouTube watch and gathering the proper tools, less than 30 minutes later Bobby, the T190, was back in action.
every other issue is this easily remedied.
Recently cleared about 1/4 mile of trail through heavy brush and small trees. Anything 4", and several of them at a time, or smaller that would fit between the teeth was cut with ease. Even cut a couple up to 8" by taking several bites around the perimeter until the final cut hit that 4" mark an slide all the into the cutting slot.
Ran into one issue when I ran the track up against a tree and forced it off the track. After a quick YouTube watch and gathering the proper tools, less than 30 minutes later Bobby, the T190, was back in action.
every other issue is this easily remedied.