Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Space between bobtach and lift arms
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 2949" data-attributes="member: 307"><p>Tazza</p><p>Your refering to the clearance between the loader arm crossmember and the bobtach?</p><p>FWIW</p><p>I'd don't have a machine like yours (743 right?) but can only tell you on my 94 753 the bobtach came so close to the cross member that the levers to release the bucket scratched the paint on the crossmemer. And I don't believe there was anything much that was not as the factory had intended it to be. Any of these loaders I have seen with the single tilt cylinder come very close to touching the levers to the cross member when the tilt cylinder is fully retracted.</p><p>Hopefully someone has a machine they can measure from for you.</p><p>Regards</p><p>Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 2949, member: 307"] Tazza Your refering to the clearance between the loader arm crossmember and the bobtach? FWIW I'd don't have a machine like yours (743 right?) but can only tell you on my 94 753 the bobtach came so close to the cross member that the levers to release the bucket scratched the paint on the crossmemer. And I don't believe there was anything much that was not as the factory had intended it to be. Any of these loaders I have seen with the single tilt cylinder come very close to touching the levers to the cross member when the tilt cylinder is fully retracted. Hopefully someone has a machine they can measure from for you. Regards Ken [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Space between bobtach and lift arms
Top
