Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
Kubota/Wacker Neuson/Hesston/IH/Ford/Other
skattrak 1050 1986
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="markplow" data-source="post: 42311" data-attributes="member: 4184"><p>Sounds like an interesting option. If the mower was set up for a 540 rpm pto, then I guess you'll be spinning it about 20% faster than intended, but that might not work too bad.... I guess you could run at 80% throttle if nothing else although this will take away some of your HP available.. Is the 1800 psi the rated pressure or the max for the motor? Your SSL should put out a max pressure much higher than this, so if it is max you will need a secondary relief valve in the system somewhere. This could be dangerous though as a relief set this much below the machine's relief will probably mean you will blowing over relief a lot. This will generate a lot of heat. I would recommend a max pressure rating for the motor of at least 10% above the machine relief setting. Hopefully that is your case.</p><p>Good luck and let me know how this works out for you.</p><p>Mark</p></blockquote><p></p>
[QUOTE="markplow, post: 42311, member: 4184"] Sounds like an interesting option. If the mower was set up for a 540 rpm pto, then I guess you'll be spinning it about 20% faster than intended, but that might not work too bad.... I guess you could run at 80% throttle if nothing else although this will take away some of your HP available.. Is the 1800 psi the rated pressure or the max for the motor? Your SSL should put out a max pressure much higher than this, so if it is max you will need a secondary relief valve in the system somewhere. This could be dangerous though as a relief set this much below the machine's relief will probably mean you will blowing over relief a lot. This will generate a lot of heat. I would recommend a max pressure rating for the motor of at least 10% above the machine relief setting. Hopefully that is your case. Good luck and let me know how this works out for you. Mark [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
Kubota/Wacker Neuson/Hesston/IH/Ford/Other
skattrak 1050 1986
Top