Reply to thread

Message: <blockquote data-quote="Axel" data-source="post: 81921" data-attributes="member: 11648"><p>So I've now realized that the alignment pin is missing. I'm trying to understand how it's supposed to work so I can make a new one... I would think it should be removed once the magnet and sensor are aligned and installed but then where should it be kept?..how do I adjust alignment if the magnet will not rotate? also having difficulty removing the magnet, the outer nut has some protrusions on it so that a socket will not slide over it, should they be ground down? it's really on there. When I rotate the bolt inside the magnet, the resistance varies as it goes full 360°, is this normal.</p></blockquote><p></p>