Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
s300 2008 shop-service manual
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 33269" data-attributes="member: 82"><p>You don't need a service manual for that.</p><p>Jack it up, remove the tyre and loosen bolts holding the hub to the axle. Use a porta power or two bottle jacks (the pump part facing down) behind the hub between the frame and hub to push the hub outwards, pump them up. Use a hammer and strike the back of the hub till it pops loose. KEEP the bolt(s) that hold it in place screwed in a little, the hub can fly out at an insane speed and cause real damage to you or someone else. Drill a hole in the seal and screw a self tapping screw into it and lever it out, Install a new seal and you're set.</p><p>Ensure your axle does not flop around, if it does, you have bad bearings that took the seal out.</p><p>I have never worked on an S300, but i'm sure the later models are all the same basic setup. There may be slight differences.</p></blockquote><p></p>
[QUOTE="Tazza, post: 33269, member: 82"] You don't need a service manual for that. Jack it up, remove the tyre and loosen bolts holding the hub to the axle. Use a porta power or two bottle jacks (the pump part facing down) behind the hub between the frame and hub to push the hub outwards, pump them up. Use a hammer and strike the back of the hub till it pops loose. KEEP the bolt(s) that hold it in place screwed in a little, the hub can fly out at an insane speed and cause real damage to you or someone else. Drill a hole in the seal and screw a self tapping screw into it and lever it out, Install a new seal and you're set. Ensure your axle does not flop around, if it does, you have bad bearings that took the seal out. I have never worked on an S300, but i'm sure the later models are all the same basic setup. There may be slight differences. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
s300 2008 shop-service manual
Top
