Reply to thread

Message: <blockquote data-quote="mrv8outboard" data-source="post: 81728" data-attributes="member: 99"><p>Seat bar switch works fine. All BICS light but "lift & tilt". The pedals are locked. Disconnect the battery, hook it back up, turn on machine (no start) and the pedals work and the light is on. Start the machine and the light goes out. No codes. If I unplug one of the two solenoids I get a code 18-06 (short to ground). If I unplug the other I get 18-07 (circuit open). It does not matter which one of the solenoids I plug unplug, they both ohm out to 5.8 and 5.9 ohms. A new one is 5.8 ohms. Since it is really hard to have circuit function properly, then short to ground and then see it open I suspected either the left panel or control module. I went to an S300 optioned similar and pulled the module and panel. Put that module in my machine and it was fine. Put the old one in , kaput no "lift & tilt. This is why I am thinking it is the module. If there is a more definitive way the test/troubleshoot please let me know. Thank you.</p></blockquote><p></p>