Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S250 BICS Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mrv8outboard" data-source="post: 81626" data-attributes="member: 99"><p>I have continued troubleshooting and have more symptoms. If I turn on the machine but do not start it I get all four BICS lights and the pedals work, I then start it and the "lift & tilt" light goes out and pedals lock. If I unplug both the lift & tilt spool lock solenoids I get a code 18-07 (Spool Lock Solenoid open circuit). If I plug one of the two solenoids back in I get no code. If I plug the other one in I get code 18-06 (Spool Lock Solenoid short to ground) you would think bad solenoid. So I ohm'ed out the solenoids and they were both 5.8 ohms. Also tried a new solenoid, same. So how can you have the same circuit open and shorted to ground? Is my control module bad? This is where I am at without a theory of operation of the module.</p></blockquote><p></p>
[QUOTE="mrv8outboard, post: 81626, member: 99"] I have continued troubleshooting and have more symptoms. If I turn on the machine but do not start it I get all four BICS lights and the pedals work, I then start it and the "lift & tilt" light goes out and pedals lock. If I unplug both the lift & tilt spool lock solenoids I get a code 18-07 (Spool Lock Solenoid open circuit). If I plug one of the two solenoids back in I get no code. If I plug the other one in I get code 18-06 (Spool Lock Solenoid short to ground) you would think bad solenoid. So I ohm'ed out the solenoids and they were both 5.8 ohms. Also tried a new solenoid, same. So how can you have the same circuit open and shorted to ground? Is my control module bad? This is where I am at without a theory of operation of the module. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S250 BICS Problem
Top
