Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S185
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="BillyDoug" data-source="post: 115592" data-attributes="member: 20264"><p>Thanks for getting back to me and I think I emailed you from the wrong email that is full. Anyway so I have the wiring harness that runs to the fuse panel out along with the fuse panel. Electrolysis have taken a toll on my fuse panel. Some of the wires have corroded so bad that the ends of the wires where they enter the back of the panel have fallen off. I'm not sure witch slot to put them back in so that they can get the right relay or fuse to them. So the wires are colored coded and they also have four digit numbers on them from the factory. I had to cut every single wires end off and crimp new ends on and put the ones back into the slots that I was positive about them going into. Now I have several wires left that were out and I'm not sure where to place them back into on the back of the fuse panel. I'll send you the colors and numbers of the wires that I have not a clue where they go. Other words the ones that are left out as of now that couldn't place back because they had fallen out and I never seen where they went to. Also I can email you some photos real quick of what I'm working with so you can put your eyes on the prize!!! Again thanks so much for getting back to me</p></blockquote><p></p>
[QUOTE="BillyDoug, post: 115592, member: 20264"] Thanks for getting back to me and I think I emailed you from the wrong email that is full. Anyway so I have the wiring harness that runs to the fuse panel out along with the fuse panel. Electrolysis have taken a toll on my fuse panel. Some of the wires have corroded so bad that the ends of the wires where they enter the back of the panel have fallen off. I’m not sure witch slot to put them back in so that they can get the right relay or fuse to them. So the wires are colored coded and they also have four digit numbers on them from the factory. I had to cut every single wires end off and crimp new ends on and put the ones back into the slots that I was positive about them going into. Now I have several wires left that were out and I’m not sure where to place them back into on the back of the fuse panel. I’ll send you the colors and numbers of the wires that I have not a clue where they go. Other words the ones that are left out as of now that couldn’t place back because they had fallen out and I never seen where they went to. Also I can email you some photos real quick of what I’m working with so you can put your eyes on the prize!!! Again thanks so much for getting back to me [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S185
Top