Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S185 Glow Plug Replacement
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Wirenut2266" data-source="post: 69636" data-attributes="member: 5883"><p>So went out today to fire machine up in 10deg. temps. Glow plugs timed out at 20 sec. and away we normally go. Instead today took way too long for engine to fire. Somewhere between 30-45 seconds. Granted it has sat for 2-3 months, a little white smoke and finally off we go. So I check voltage to plugs ok, pull out and ohm, all okay. Then test on bench with spare battery, glow red at last 1/4"-3/8" of probe after only 10 sconds or less. These plugs probable are original with 4600 hours. this "seems" okay, but was wondering if I should swap out plugs. Only a 20 minute job, but the plugs are a NGK 4693 (Y716SR) at about $25/e at Napa.......I could not find a cross anywhere? Thanks, Bruce</p></blockquote><p></p>
[QUOTE="Wirenut2266, post: 69636, member: 5883"] So went out today to fire machine up in 10deg. temps. Glow plugs timed out at 20 sec. and away we normally go. Instead today took way too long for engine to fire. Somewhere between 30-45 seconds. Granted it has sat for 2-3 months, a little white smoke and finally off we go. So I check voltage to plugs ok, pull out and ohm, all okay. Then test on bench with spare battery, glow red at last 1/4"-3/8" of probe after only 10 sconds or less. These plugs probable are original with 4600 hours. this "seems" okay, but was wondering if I should swap out plugs. Only a 20 minute job, but the plugs are a NGK 4693 (Y716SR) at about $25/e at Napa.......I could not find a cross anywhere? Thanks, Bruce [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
S185 Glow Plug Replacement
Top
