Reply to thread

Message: <blockquote data-quote="logan1211" data-source="post: 128236" data-attributes="member: 23567">Hey everyone, Recently did pins and bushings on my S185. I accidentally damaged the threads on the little plate where the grease zerk goes on the backside of the tapered pin on the lower Bobtach attachment. I went to touch those threads up and broke my tap off... cheap metal. Lesson learned. Anyway, I can't get this dang broken bit out. Super hard and apparently very brittle, struggling to weld to it or get a drill bit in for easy out.Was just going to order new... problem is, I can't find this part anywhere. Anyone know what'd I should be searching for or can recommend here? This is the small plate/disc held in by the snap ring on the inside of the tapered pin. (Pic attached) Thanks in advance!</blockquote>