Reply to thread

Message: <blockquote data-quote="BillB" data-source="post: 96849" data-attributes="member: 11733"><p>Latest update on my BobCat's Joystick Problem. I tried everything with no improvements so I finally bought a new one. It was suggested that it wouldn't work without being calibrated. I installed it and when following the Calibration Instructions, couldn't get the final confirmation that it had calibrated. Regardless, it seemed to work just fine anyway so I was able to get back to work on my property. Shortly after that though, one of the lift cylinders blew a Seal so I got some on eBay as my local dealer didn't have them in stock. I replaced seals in both Lift Cylinders. Also had gotten a flat while it was sitting. Thought I would have to got to extremes to get the tire to seat on the rim. But after sitting over night off the ground, I was able to just soap it down and fill it with air and the Bead seated just fine. I did blow a hose on the 4/1 Bucket for which the local dealer didn't have a replacement in stock but was able to get one made while I waited at Hydraulic Service Shop. Almost got my yard done now as 7,000 sq ft of Zoysia El Toro was spayed on yesterday! Gotta finish some sprinkler piping and electrical lines in trenches and then fill and level. Then more Hydroseeding.</p></blockquote><p></p>