Reply to thread

Message: <blockquote data-quote="6brnorma" data-source="post: 75461" data-attributes="member: 5914"><p>Those parts are all available through Bobcat. I would recommend a couple of each in case of foul up when reassembling. The 'carbide' seal (Part #6516301) is about $20.00 and is the easiest to break when reassembling so be careful with it……also O-ring (#25k-20005), spring (#6516302), and guide [steel washer] (#888670) are all a couple of bucks each. If you need the swivel it too is available through Bobcat but is nearly $100.00……if you're going to do all that, I'd replace the snap rings and bearings also. Now for the stationary sheave……there are two small bolt holes at the base of the sheave…..put short bolts in the holes (snug), use a bearing splitter and a puller to pull the sheave. Under no circumstances pry behind that sheave…..it is EASY to break and over $600.00 to replace.</p></blockquote><p></p>